![]() You would then want to perform the same process on the next line for your webport which by default would be 80 or the new value if changed in the step above and again forward it to the actual IP Address of the Control Processor. In the next field you would select the actual IP address of the Control Processor and then you would click the box for enable. The protocol if you are unsure you should select both TCP and UDP protocols. This gives you a port forwarding range where you would type in 41794 to 41795. ![]() On the Linksys brand it is most commonly referred to as the Applications and Gaming tab. On many routers it is phrased differently as to what portion controls port forwarding for that particular router. Note: Console command, in the window will return the current web server setting. When uploading a new eControl or iPhone Mobile application the Webserver is turned on by default.Ĭonnect to the Control Processor using Toolbox, view. Select from the pull down menu, , be sure the check box is selected in the top left of the pop window. When trying to access this via eControl then type in the Address bar of the browser, public_ip_address : portnumber, for example 67.82.225.268:81 Note: Console command, in the window will return the current web port setting.īy default the value is 80 which is very commonly blocked by cable modem providers.Įnter the new value in the HTTP Port field and select and The window of the view will return the current Web Port setting in the field The CTPPORT is 41795, this port is used for viewport/toolbox connections to the processor.īoth ports can be changed by typing in CTPPORT or CIPPORT and then the number that you want the port to be. ![]() The CIPPORT is 41794, this port is used for Ethernet control such as in xpanel and roomview. Note: Console commands, and in the window will return the current settings of the processor. The window of the view will return the current CIPPORT and CTPPORT. Note: Console command, in the window will return all of your IP information including the IP address of the processor. The window of the view will return the current Control Processor settings ![]() Select then, the processor will then reboot Note: If assigning a fixed IP Address, this must be outside of the DHCP range of the Router being used.Ģ) Assign the Default Router to the Control Processor, this should be the local IP Address of the installed Router being used. Select from the pull down menu, ġ) Assign an IP Address and IP Mask that is within the range of the installed routerĮx. You need to assign 3 IP fields, IP Address, IP Mask, Default Router. How to setup the Control Processors IP address:Ĭonnect to the Control Processor using Toolbox, view. Note: For a Linksys router it is under the status tab.Īn easy way to find your public IP Address is to hook a computer up through the router and go to here. Note: Additional information can be found in the eControl Reference Guide.ģ) Your CIPPORT and CTPPORT on the Control Processorĥ) Viewport or Toolbox, either can be used for all of the described tasks.ĭifferent routers show this in different places. Connecting to your processor remotely, what to Setup and Configure:
0 Comments
Leave a Reply. |